將材料均勻地噴灑在地面上,保持地面濕潤.三十分鐘后,我們可以用長頭發反復推地面.目的是為了使材料吸收更好,注意長發刷的中等硬度.當混凝土密封劑變得越來越厚時,可以用水噴灑在地面上,并結合長毛推刷,使多余的材料完全滲入地面.當材料再次變厚時,整個地面可以用水沖洗,而刷子則用長發來回推,使粘稠的東西漂浮起來,待地面干燥后再清洗表面.

Spray the material evenly on the ground to keep it moist. Thirty minutes later, we can push the ground repeatedly with long hair. The purpose is to make the material absorb better and pay attention to the medium hardness of the long hair brush. When the concrete sealant becomes thicker and thicker, water can be sprayed on the ground, combined with the long hair brush, so that the excess material completely penetrates into the ground. When the material becomes thicker again, the whole ground will be covered. The surface can be washed with water, while the brush can be pushed back and forth with long hair to make the sticky things float up and wash the surface after the ground is dry. 混凝土密封凝固劑施工后的地面表面不粘,如果表面粘著,說明地面不干凈,需要再次沖洗干燥.沒有干凈的地面容易出現白斑,會嚴重影響地面的外觀,所以沖洗和清洗是非常重要的步驟.

The surface of the ground after the construction of concrete sealant is not sticky. If the surface is sticky, it means that the ground is not clean and needs to be washed and dried again. Without clean ground, white spots easily appear, which will seriously affect the appearance of the ground, so washing and cleaning are very important steps.

施工環境溫度應保持在1.7 - 57攝氏度范圍內,過高或過低的溫度會影響地板養護質量.混凝土密封固化劑地板的施工時間約為1 - 3小時,地面干燥后即可離開.

The construction environment temperature should be kept in the range of 1.7-57 degrees Celsius, too high or too low temperature will affect the quality of floor maintenance. The construction time of concrete sealant curing agent floor is about 1-3 hours, and the ground can leave after drying.

為了使地面盡可能長,新建的混凝土密封養護劑地板需要節約用水.節約用水需要持續7天.目的是幫助地面鎖住水分,加速密封地板,使地面具有足夠的硬度和硬度,不會出現裂縫.

In order to make the floor as long as possible, the new concrete sealant floor needs to save water. It needs to save water for 7 days. The purpose is to help the ground lock water, accelerate the sealing floor, so that the ground has enough hardness and hardness, without cracks.