環氧地坪漆遇水變白是指涂層在干燥過程中，環氧地坪漆表面產生霧狀導致光澤度下降，直接影響了環氧地坪的裝飾效果。因此，為了確保工程質量，一定要杜絕環氧地坪漆雨水變白現象的產生。下面，環氧地坪漆廠家就給大家分享環氧地坪漆遇水變白的原因、預防措施及解決辦法。環氧地坪漆遇水變白的主要原因：

The whitening of epoxy floor paint in water refers to the foggy appearance on the surface of the coating during the drying process, which results in the decrease of gloss and directly affects the decorative effect of the epoxy floor paint. Therefore, in order to ensure the quality of the project, it is necessary to eliminate the phenomenon of rainwater whitening of epoxy floor paint. Next, epoxy floor paint manufacturers will share with you the reasons for the whitening of epoxy floor paint in water, preventive measures and solutions. The main reasons for the whitening of epoxy floor paint in the presence of water are as follows: 1、施工周圍環境濕度過大，導致空氣中的水分直接進人涂層。

1. The ambient humidity around the construction is too high, which causes the moisture in the air to enter directly into the coating.

2、當空氣溫度低、濕度大的時候，涂層中的溶劑揮發速度將會引起涂層表面溫度急劇下降，很容易使空氣中的濕氣在涂層表面凝結成水分浸入涂層中，結果導致霧狀發白，并將此種發白稱為“潮濕性發白”。

2. When the air temperature is low and the humidity is high, the solvent evaporation rate in the coating will cause the surface temperature of the coating to drop sharply. It is easy to make the moisture in the air condense on the coating surface into water and immerse in the coating. As a result, the foggy whitening will occur, and this kind of whitening will be called "wet whitening".

3、由于涂料中的真溶劑揮發比其稀釋劑快得過多，結果引起涂層中部分樹脂析出成白色沉淀，使涂層發白，并將這種發白稱為“樹脂性發白”。

3. Because the volatilization of real solvent in coatings is faster than that of diluents, some resins in coatings precipitate into white precipitation, which makes the coatings white. This kind of whitening is called "resin whitening".

為避免環氧地坪漆遇水發白應做好以下三點：

In order to avoid the whitening of epoxy floor paint in water, the following three points should be done well:

1、提高涂飾施工環境的溫度減少空氣的濕度。

1. Raise the temperature of painting construction environment and reduce the humidity of air.

2、在涂料中要適當增加真溶劑與稀釋劑的沸點。

2. The boiling points of real solvents and diluents should be properly increased in coatings.

3、按照環氧環氧地坪漆施工工藝施工時，確保施工環境溫度在10-30℃之間。過低或者過高都會影響地坪漆的反應過程，造成固化不良。

3. In accordance with the construction technology of epoxy floor paint, ensure that the construction environment temperature is between 10-30 degrees Celsius. Too low or too high will affect the reaction process of floor paint, resulting in poor curing.

當環氧地坪漆出現發白現象時可以采用以下措施進行改善：

When the whitening of epoxy floor paint occurs, the following measures can be taken to improve it:

1、適當增加涂層干燥溫度，在條件允許的情況下采用紅外線輻射器干燥涂層，使潮氣從涂層中揮發掉。

1. Increase the drying temperature of the coating properly, and use infrared radiator to dry the coating when conditions permit, so that the moisture evaporates from the coating.

2、在涂層發白處輕輕刷涂一層薄薄的該涂料的真溶劑，使涂層中析出的樹脂重新溶解成連續的涂層，或使涂層中的水氣自由的揮發出去。

2. Gently brush a thin layer of true solvent on the whitening part of the coating to dissolve the resin precipitated from the coating into a continuous coating, or to make the water vapor in the coating volatilize freely.